Analog Devices Inc. SoundMAX(R) 2.1 Audio

SoundMAX 2.1 is designed for and tested with Windows(R) 98SE, 
Windows 2000, and Windows Millennium.


INSTALLATION AND REMOVAL INSTRUCTIONS:

Installation or Update of Analog Devices SoundMAX, SoundMAX 2.0, or 
SoundMAX 2.1 Audio Driver

  NOTE: Remove any previously installed driver using the instructions
        in the next section.

1.  From the task bar, click on Start -> Run.

2.  In the Run dialog box, type X:\path\setup, where X:\path is the
    full path to the source files.

3.  Click on the OK button or press the ENTER key.

4.  Click on the Next and OK prompts as they appear.

5.  Reboot the system to complete the driver installation.


Removal of Analog Devices SoundMAX, SoundMAX 2.0, or SoundMAX 2.1 
Audio Driver

1.  From the task bar, click on Start -> Settings -> Control Panel.

2.  Double-click on the Add/Remove programs icon. 

3.  Double-click on SoundMAX2 if you currently have SoundMAX 2.0 or 
    SoundMAX 2.1 installed. Double-click on SoundMAXWDM if you only
    have the driver installed. 

4.  Reboot the system to fully uninstall the drivers.


UNATTENDED (SILENT) INSTALLATION INSTRUCTIONS:

Unattended installations use an InstallShield Silent Response
File (setup.iss) to provide user input.

Running an Unattended Installation

Run SETUP.EXE as described in the installation section above, but with
the -s parameter to use the .iss file that is provided with the driver.
      
To use a different setup.iss file, use the -f1 parameter to provide the
full path to the file.

  NOTE: When running an installation in silent mode, no messages
        are displayed. Instead, a log file named Setup.log captures
        installation information, including whether the installation
        was successful. The -f2 parameter can be used to control
        where the log file is created.


Creating a Custom Silent Response File

Run Setup.exe as directed above, but with the -r parameter to record
the install responses in setup.iss. Use the -f1 parameter to control
where the .iss file is created. The line below creates setup.iss
in the c:\tmp directory.

		SETUP.EXE -r -f1c:\tmp\setup.iss



HARDWARE AND SOFTWARE DEPENDENCIES:

This software has been designed for and tested with Windows(R) 98SE,
Windows 2000, and Windows ME.

There are issues with Windows 98 Gold that will cause problems. 

1.  The system must contain either an ICH chip set or a 
    VIA Super South Bridge chip set.

2.  One of the following operating systems must be installed on the
    system:

        Windows 98 SE	 4.10.2222A with QFE 242937USA8
        Windows ME	 4.90.3000
	Windows 2000     with Service Pack 1 (SP1)

	Note: Microsoft has also released "Compatibility Updates" for
        Windows 2000 that address problems with specific applications.
        For a list of affected applications, visit:

	http://www.microsoft.com/windows2000/downloads/deployment/
               appcompat/default.asp

3.  Game setup:

	Quake3: Enable A3D each time the game is loaded.

	Unreal Tournament: After installing, enable "3D Hardware" in 
        Sound Options and restart the game.

This driver is built for the Microsoft(R) Windows Operating Systems.


Copyright 2000, Analog Devices, Inc. All names mentioned herein are a
registered trademark or a trademark of Analog Devices or its respective
owners. All rights reserved. 

			Document Rev. 1.01