Analog Devices Inc. SoundMAX(R) Windows NT(R) 4.0 Driver


Driver Version: 4.02.00.0050


INSTALLATION AND REMOVAL INSTRUCTIONS:

Installation or Update of Analog Devices SoundMAX Audio Driver

  NOTE: Remove any previously installed driver using the instructions
        in the next section.

1.  From the task bar, click on Start -> Run.

2.  In the Run dialog box, type X:\path\setup, where X:\path is the
    full path to the source files.

3.  Click on the OK button or press the ENTER key.

4.  Click on the Next and OK prompts as they appear.



Removal of Analog Devices SoundMAX Audio Driver

1.  From the task bar, click on Start -> Settings -> Control Panel.

2.  Double-click on the Add/Remove programs icon. 

3.  Double-click on SoundMAXNT uninstall.  

4.  Click on the Next prompt in the "Setup Complete" dialog box to 
    proceed with reboot. Setup will resume after reboot.

UNATTENDED (SILENT) INSTALLATION INSTRUCTIONS:

Unattended installations use an InstallShield Silent Response
File (setup.iss) to provide user input.

Running an Unattended Installation

Run SETUP.EXE as described in the installation section above, but with
the -s parameter to use the .iss file that is provided with the driver.
      
To use a different setup.iss file, use the -f1 parameter to provide the
full path to the file.

  NOTE: When running an installation in silent mode, no messages
        are displayed. Instead, a log file named Setup.log captures
        installation information, including whether the installation
        was successful. The -f2 parameter can be used to control
        where the log file is created.


Creating a Custom Silent Response File

Run Setup.exe as directed above, but with the -r parameter to record
the install responses in setup.iss. Use the -f1 parameter to control
where the .iss file is created. The line below creates setup.iss
in the c:\tmp directory.

		SETUP.EXE -r -f1c:\tmp\setup.iss



HARDWARE AND SOFTWARE DEPENDENCIES:

This driver has been designed for and tested with Windows NT 4.0.

1.  The system must contain either an ICH chip set or a 
    VIA Super South Bridge chip set.

2.  The Windows NT 4.0, Service Pack 4 or greater, must be installed
    on the system.


This driver is built for the Microsoft(R) Windows(R) Operating Systems.


Copyright 2000 - 2001, Analog Devices, Inc. All names mentioned herein 
are a registered trademark or a trademark of Analog Devices or its 
respective owners. All rights reserved. 

			Document Rev. 1.02