![[Prev]](images/blue_prev.gif)
![[Next]](images/blue_next.gif)
![[Contents]](images/blue_toc.gif)
![[Commodore]](images/blue_cbm.gif)
![[New]](images/blue_new.gif)
![[Home]](images/blue_home.gif)
OVERVIEW
The drive itself an independent memory device. THe drive is composed of a media
clamp rotating mechanism, a head positioning mechanism and an eject mechanism.
All positioning operations, excluding insertion and removal of diskettes, are
controlled by the internal guide mechanism. Closing the front door causes the
media clamp mechanism to operate. Two operations are performed in the following
order:
- a)
- The diskette is centered.
- b)
- The diskette is clamped and retained between the spindle and the hub.
The spindle and hub rotates at 300 r.p.m. through a closed/loop control circuit
employing a D.C motor/tachometer. It is important that the relationship between
the head and the media is maintained correctly during operation. For this
purpose, a pressure pad is used to hold and press down the media (about 12g)
from the opposite side of the head. This head assembly is coupled by a metal
band to a four base stepping motor which performs the track positioning. One
step of the stepping motor corresponds to a 1/2 track movement. The control
circuit on the logic board selects the direction and number of steps to the
desired track.
The Read/Write head uses a glass-bonded, ferrite/ceramic head. Track-to-track
erasing is accomplished by the straddle erase method. The surface of the
Read/Write head is mirror-ground to minimize wear of the head and media. Also,
the head is designed in such a way that the maximum signal can be obtained from
the media surface.
The spindle drive motor operates on 12 VDC and turns the spindle, through a belt
drive, at 300 revolutions per minute. The speed of the drive motor is controlled
by a feedback signal from a tachometer, which is housed in the drive motor
assembly. The feedback signal controls a servo amp that supplies the 12 VDC
drive current.
The 1541, upon power-up, goes through its own internal diagnostic. If an
electronic problem is detected, it's indicated by flash code. The led's will
blink a number of times, pause, and then flash again until the problem is
corrected.
| Number of flashes | Possible failure |
|---|
| 2 | Zero page |
| 3,4 | DOS ROM's |
| 5,6,7,8 | RAM |
Circuitry associated with these components can also cause the failure code.
Therefore, it should be suspected as the next possible defect.
This page has been created by Sami Rautiainen.
Last updated February 11, 1998.
Read the small print.