Below is a list of the Top Netware / Other Network Questions


-1-
Q:  What are the latest versions of firmware and utilities for the network adapters?
A:  Call Technical Support at 606-232-3000.

-2-
Q:  Do the network adapters support NDS in Netware 4.1 in Pserver mode?
A:  Version x.94.1 of firmware on the adaptor does to some extent but has
      various problems which should be resolved with the production level of
      firmware by the end of May (1996).

-3-
Q:  Why does the Netware login name not show up for adapters in Markvision for
      Windows 95?.
A:  Markvision must be installed using the "Custom" option under which support
      for Netware should be selected.

-4-
Q:  Why does a PC running Netware's Rprinter.exe locks up when a print job comes
       through while windows is running?
A:  Remark the following lines out of the system.ini:
      Device = lex01.386,
      Device = vpd.386.

-5-
Q:  What can be done to improve print speed through Novell's Rprinter.exe when
       printing is noticeably slow?
A:  Run Rprinter in polled mode.

-6-
Q:  How can I stop the garbage that prints from windows?
A:  1. Remark "Device = lex01.386" and "Device = vpd.386" out of the system.ini.
      2. Disable Tabs conversion in the Netware capture statement.
      3. \windows\system\netware.drv dated other than 10/24/94, especially older
          versions, running with ipxodi and vlms in Netware 3.x has been known to
         cause hundreds of pages with just a couple charaters on each page.
    4. Old versions of Pserver have been known to insert data into the
        datastream in Netware 3.x.  The current version of Pserver in Netware
        3.x is 3.76.

-7-
Q:  I just installed an internal network adapter and now the printer's operator
      panel covered with diamonds. Why?
A:  This happens with many of the older printers including the 4039 10R/12R/12L
      and the 4039 10R+/12R+/12L+ which require a supplemental power supply
      (dc to dc converter).  The part number for the power supply (1429981) and a
      complete list of applicable printers is printed on the packaging for the
      adapter.

-8-
Q:  Why does the adapter intermittently discontinue servicing a queue and
       have to be reset?
A:  Update the firmware revision.  Call Tech Support for the latest.

-9-
Q:  What can I do to remedy problems printing over Lantastic when windows
       is running?
A:  1. Remark "Device = lex01.386" and "Device = vpd.386" out of the system.ini.
      2. If the PCL driver is being used, disable "Optimize for performance."