Bsp2Wad.exe    by Geoff Phillips   (c) 1997  Version 2
(bug for Erased texture fixed)

This program, written in assembler, lifts all the textures out of a BSP file
as used in Quake, and creates a texture file (.WAD) ready for use
in  Worldcraft or some other editor.

To run, simply type BSP2WAD file.bsp  and instantly (because it's a fast piece
of assembler code, and not any of this high-level "%&!^) you have your wad file.
You can also specify an output filename, so BSP2WAD file.bsp blob.wad.


---------------------------------------------------------------------------
;tamper protection: the isitsame value for this exe is "Managers shake baldly
with a book", if you want isitsame.exe to check this, go to my page


Rights reserved.  This program may be freely distributed, but not may sold
or released with other packages without my prior consent.
Worldcraft is a trademark of Ben Morris, and Quake is a trademark of ID
software.

Contact binky@DeathsDoor.com or write to 9 The Don, Bletchley Milton Keynes
MK3 7PX England.  If Bletchley sounds a dull place, just remember it was
here that Colossus was built during World War 2, Turing, Enigma blah blah.


Disclaimer:  If this program causes you any injury or loss, tough.  Use at
your risk, though it's hard to see what on earth this program could do with
simple file handling.